Filter
Top Products
Page 6-9
Section 6. Replacement Procedures
SATO CL608e/CL612e Service Manual
PN 9001079
Rev. B
The Power Supply is a non-repairable component with no servicable parts and is
to be replaced as a complete assembly.
STEP PROCEDURE
1. Switch the printer OFF and disconnect the power cable.
2. Remove (3) screws holding the left side cover to the printer. Raise the access
door and loosen the (2) screws on the inside top of the printer. Lift off the left
side cover to expose the main PCB. Fig. 6-1
3. Remove (2) screws holding the I/O PCB Interface from the back end of the
unit. Pull away to detach the connector on the interface from the main PCB.
Figs. 6-8
4. Remove (2) screws to detach the main circuit board. Figs. 6-9
5. Remove (2) screws to which secures the board mounting plate to the back side
of the unit. Fig. 6-9
6. Remove (2) screws to detach the Board Mounting Plate and carefully move out
of the way of the Power Supply Assembly. Figs. 6-10 & 6-11
7. Remove (2) screws to which secures the power supply to the back side of the
unit. Fig. 6-12
8. Lower the Media Holder in the mechanical section of the printer for access to
(2) screws holding the power supply. Remove the screws. Figs. 6-13 & 6-14
9. Detach (2) cable connections and remove the defective Power Supply.
Fig. 6-15
10. Install a replacement Power Supply reversing steps 1 through 9.
11. Check the DC power voltages. Refer to Section 4.3.
6.4 Replacing the Power Supply