Filter
Top Products
Page 2-10
Section 2. Configuration
SATO CL608e/CL612e Service Manual
PN 9001079
Rev. B
There are three Speed settings on the printer. The setting is listed on the bottom
line of the display. The current setting is indicated by an underline under one of
the speed settings. To change the setting:
STEP PROCEDURE
1. Use the LINE key to step the underlined cursor to the desired
speed setting.
4 = 4 in/s (100mm/s)
6 = 6 in/s (150mm/s)
8 = 8 in/s (200mm/s)
2. Once the correct setting is underlined, press the FEED key to
accept the setting and advance to the next adjustment.
Print Speed Adjustment
PRINT speed
468
The label pitch is the distance from the leading edge (the edge that comes out of the
printer first) of a label and the leading edge of the next label. The leading edge position of
the label can be adjusted relative to the print head +/- 49mm in increments of 1mm.
Once the position is set, it can be fine adjusted +/- 3.75mm using the PITCH
potentiometer on the adjustment panel.
Pitch Offset Adjustment
pitch offset
+00mm
STEP PROCEDURE
1. The underline cursor will initially be positioned underneath the Pitch
Direction setting. Use the LINE key to step the underline to either the
positive (+) or negative (-) selection. A position selection moves the
leading edge of the label forward (away from the print head) while a
negative selection moves the leading edge of the label back into the
mechansim.
2. Once the correct setting is underlined, press the FEED key to
accept the setting and advance to the Offset adjustment.
3. Use the LINE Key to step the first digit of the counter to the desired setting.
The display will increment one step each time the LINE key is pressed. The
reading will advance to a setting of 4 after which it will automatically wrap
and start at 0 again.
LCD Panel — Normal Mode