Filter
Top Products
Page 9-9
Section 9. Optional Accessories
SATO CL608e/CL612e Service Manual
PN 9001079
Rev. B
Label Dispenser Installation
STEP PROCEDURE
4. Remove (3) motor mounting screws attaching motor to the frame. Fig. 9-10
5. Refer to Section 6.2 and remove the main circuit board.
6. Detach the front cover from the printer by removing (5) screws. Figs. 9-11
7. Refer to Fig. 9-8a & Figs. 9-12
Place spring on pin (both ends) and attach roller with flat area of shaft over
spring and into hole (both ends).
8. Refer to Fig. 9-8b & Figs. 9-13
Install Dispenser Feed Roller Assembly through hole in space vacated by motor
and into right side frame using hardware supplied.
9. Refer to Fig. 9-8c and Fig. 9-14a
Install the Idler Gear directly above the gear on the end of the feed roller
assembly installed in Step 8. The idler gear should mesh freely with feed roller
gear when installed correctly.
10. Refer to Fig. 9-8c and Fig. 9-14b
Install idler pulley with large teeth in/small teeth facing out.
11. Refer to Fig. 9-8d and Fig. 9-14c
Remove the "E" clip and pulley from bracket. Route the drive belt over the gear.
Insert the gear shaft through the hole in the printer wall. Attach the bracket to
the printer wall from the opposite side with (4) screws provided. Install the "O"
ring pulley, shoulder side first and reattach the "E" clip to the end of the shaft.
Attach belt from the gear on this assembly to the gear on the idler pulley as
shown in Figs. 9-14.
12. Refer to Fig. 9-8c and Figs. 9-14d
Attach the tension roller to the printer as shown in Figs. 9-14 with hardware
provided. Attach right screw first then attach and tighten the screw in the
adjustment slot.
13. Refer to Fig. 9-8e and Figs. 9-15 & 9-16
Install the rewinder assembly to the back of the printer with (2) screws
provided. Run the "O" belt from the rewinder assembly through the back of the
printer and onto the rewind pulley installed in step 11.
14. Refer to Fig. 9-8e and Figs. 9-17
Attach the pulley cover over the exposed pulley and belt with (1) screw
provided.