Filter
Top Products
Page 2-35
Section 2. Configuration
SATO CL608e/CL612e Service Manual
PN 9001079
Rev. B
LCD Panel — Maintenance Mode — Factory Mode
STEP PROCEDURE
1. Record all current dip switch positions, then place all switches in the OFFposition.
2. Place the DSW2-4 in the ON or up position.
3. Press the LINE and FEED key while simultaneously turning ON the power switch.
When the printer beeps, release the keys. The following screens will appear.
4. Place the DSW2-4 in the OFF position and the following screen will appear.
5. Press the FEED key to display the next screen.
6. Press the LINE key once to change the message to the proper selection.
The counters are identified in the display as:
HD: Head Counter (should be reset only when a print head is replaced).
DSP: Dispense Counter - meters of label stock dispensed.
CUT: Cutter Counter - number of cutter cycles.
LIFE: Life Counter (cannot be reset) meters of label stock run through the printer.
ALL: Clears all counters and resets firmware and returns printer to factory default
setting. This setting is used when upgrading firmware.
7. Press the FEED key to clear the selected function. After a pause, the next screen will
appear.
8. Select the print label size by pressing the LINE key. The default is LARGE.
9. Press the FEED key for a test print. Press the FEED key again to stop printing.
This function is used to clear counters and reset the printer's firmware.
This procedure is used after upgrading the flash firmware or installing a new memory
module.
counter clear
all
test print
press feed key
print size
small large
counter clear
none
factory mode
initializing
rom v00.00.00.00
maintenance mode
diPSw2-4 on->off