Filter
Top Products
Page 2-18
Section 2. Configuration
SATO CL608e/CL612e Service Manual
PN 9001079
Rev. B
STEP PROCEDURE
1. Use the LINE key to step the underlined cursor to the desired setting.
IF Yes is selected, the printer will enter the Card Copy mode.
If No is selected, the display will advance to Card to Memory Copy
SATO Font mode. Press the FEED key to accept the selection and
advance the display.
2. Confirm your selection by stepping the underline cursor to the Yes
selection. If you select No, the display will return to the previous
selection.
3. Press the FEED key to accept the selection. If Yes was selected, the
copy process will start.
4. Once the copy process is completed, press the FEED key to advance
the display.
5. If an error is encountered in the copy process, one of the following
messages will be displayed on the second line.
R/W Error Indicates a Read/Write error occurred
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient
memory available
card ->MemoryCopy
TrueTypeFont y/n
This selection allows you to copy TrueType fonts from the PCMCIA Memory card installed
in the Memory Card slot (on the rear of the printer) to the optional Flash ROM.
Card ->MemoryCopy
TrueTypeFont Y/N
copy start
yes no
truetypefontcopy
copying
truetypefontcopy
completed
CARD COPY/FORMAT
XXXXXXX ERROR
LCD Panel — Card Mode