Filter
Top Products
93
TROUBLESHOOTING
7
SELF-DIAGNOSTIC FUNCTION
The machine has a self-diagnostic function that automatically stops operation if a problem occurs in the machine. If
a problem occurs in fax mode, the following display appears.
MESSAGES DURING NORMAL OPERATION
Toner is low. Toner is low. Replace the toner
cartridge.
"REPLACING THE
TONER CARTRIDGE" in
the Operation Guide for
the machine
Add toner.
Can not copy or print.
[OK]:RETURN
There is no toner. Replace the toner
cartridge.
"REPLACING THE
TONER CARTRIDGE" in
the Operation Guide for
the machine
Unfold original and
return XX
original(s) to the
document feeder.
[START]:CONTINUE
The detected original size
is smaller than the actual
original size, or a smaller
size has been selected.
Place the originals again
and make sure that the
size indicated in the
display is the same as the
actual original size.
–
Message display Action
Call for service.
code:xx xx.
Turn off the power and then turn it back on. If the error is not cleared, note the 2-digit
main code and the 2-digit sub-code and then contact your dealer.
Message Meaning of message
SENT xx%
No.001 P-xxx
This appears when a direct transmission ends ("xx" indicates the number of pages).
READING xx%
No.001 P-xxx
The original is being scanned into memory (during memory transmission).
Stand-by. 100%
22 AUG FRI 10:25
The machine is in the standby state.
ENTER DIAL # This appears when the [SPEAKER] key has been pressed.
Message
(alarm sounds)
Meaning of message Solution Page
Main code
Sub code