Filter
Top Products
Configuring the SMART Hub SE240 41
In addition, you can view the SMART Hub SE240’s system information, including the firmware
version, Internet Protocol (IP) address and Media Access Control (MAC) address.
1. Press Menu.
The Welcome Center appears.
2. Press Settings.
The Settings dialog box appears.
3. If a password is required to change the configuration settings, type the password in the box at
the bottom of the menu, and then press OK.
NOTE: For information on the configuration settings password, see page 20.
4. Press System and Language.
5. In the Language list, select your preferred language.
6. Press Apply All.
You’ve set the SMART Hub SE240’s user interface language.
IMPORTANT
The initial version of the SMART Hub SE240 firmware does not support these other
languages. A later version of the firmware will support these languages. For
instructions on updating to the latest version of the firmware, see page 75.
To set the SMART Hub SE240’s user interface language