Filter
Top Products
Chapter 4. Configuring the Library
46
5. Touch the + and - symbols next to the SCSI Bus 2 ID button to scroll through
the SCSI IDs and select the appropriate setting.
6. Touch Save Parms > Yes
to restart the library and save changes.
7. Power off the library and reconnect the system SCSI cables.
8. Power on the library, and, after it comes ready, turn on any other peripheral
equipment and confirm proper operation of the system.
Note: If the library is in the dual SCSI mode (SCSI busses are not
connected with the SCSI link) and SCSI ID 2 is off, Drive 3 and
Drive 4 will power up with an error until the second SCSI bus ID is
properly configured.
Split-Bus Operation Only: Library 2 Slots
If you configured the library to be shared by two hosts (as two logical libraries), as
discussed in Selecting the Mode of Library Operation on page 29, you must configure
the Library 2 Slots setting.
Library 2 Slots Defines the slots for the second logical library, allocated in multiples of
10. If you have only configured the library to use one host, leave this setting off.
• Touch the + and - symbols to enable or disable slots, depending on whether you
have configured a second logical library.
• Touch Save Parms > Yes to restart the library and have the changes take effect.