Filter
Top Products
Chapter 4. Configuring the Library
49
Time
Set the time from the first Configuration screen. To get there from the main screen,
press Config. This procedure sets only the time the displayed on the library’s front
panel; it does not affect any time settings used by the host or backup software.
To set the time:
1. Press the + or - symbols on either side of the 12/24 Hour Time button,
depending on the format in which you want the time displayed. The enabled
setting of 12 or 24 appears next to the button.
2. Press the Set Time button. The Set Time dialog appears.
3. Enter the hour (a number between 0 and 23, depending on whether you have
chosen 12-hour or 24-hour time), then touch OK.
4. Enter the minutes (a number between 0 and 59), then touch OK.
5. Enter the seconds (a number between 0 and 59), then touch OK.
6. Touch Save Parms > No; the changes are saved without restarting the library.
Note: Touch Back to backspace over an entered number. Touch Exit to
cancel changes without saving and return to the configuration
screen.
Library Emulation
The library can emulate other library types for compatibility with your host system. Set
the library emulation from the second Configuration screen; to get there from the main
screen, press Config > More.
1. Touch the + or - symbols to view the available choices.
2. Select the emulation you want, then touch Save Parms > Yes; it is necessary to
restart the library for these changes to take effect.
RS-232 Handshake
Set serial port handshaking from the second configuration screen; from the main
screen, press Config > More. If you are not using a backup package which requires a
serial connection between the library and the host, you can ignore this setting.
• Touch + to enable hardware handshaking on the serial port, or touch - to disable
handshaking.
• Touch Save Parms > No, because it is not necessary to restart the library for these
changes to take effect.