Filter
Top Products
The resultsofthefollowingcommands depend on the positionsof PI and P2:
DR. FT, IW, LB, LT. PW, RO, SC, SR, WU.
I r c
IR [P]r.~,Pln [,P2r.x,P2ry :]]
This command establishes new or default locations for the scaling points P1
and P2 relative to the picture frame size. PI andP2 are used by the Scale (SC)
command to establish user-unit scaling. IR can also be used in advanced
techniquessuchasprinting mirror images,enlarging/reducingdrawings, and
enlarging/reducing relative character size,orchanging label(text)direction.
The coordinates of pointsP1 and P2 are expressed as percentage of the width
(height) of the picture frame.
I w c
IW [x11,J1l,.t-ur.>wr;]
This command sets the position and size of the soft-clip window and
determines theeffective clip window asthe intersectionoftheprintable area,
the logical page, the picture frame and the soft-clip window.
The meanings of parameters are:
X11 x-coordinate of lower left corner of soft-clip window
y[l
y-coordinate of lower left comer of soft-clip window
.Kur x-coordinate of upper right corner of soft-clip window
.)’ur
y-coorclinak of upper right corner of soft-clip window
P e c
The following commands cause aconditionalpageeject, meaning thatapage
will be ejected if there is any printable data in the print buffer:
Reset command, <ESC> E
Page length command
Page size command
Orientation command
Paper source command
When a page isejected usingone oftheabovecommands, the cursorposition
is set to the top of form on the new page.
103