Filter
Top Products
in which n isthenumberofdots defining the thicknessoftherule orthedepth
of the pattern.
Alternatively, to show the vertical dimension in decipoints, you send this
command:
<ESC> *c n V
in which n is the number of decipoints in the rule’s thicknessor the pattern’s
vertical length.
4 C a p a r o p
You need the next five commands to choose and print the particular pattern
you want to fill your defined area. These commands work together.
With the Print Pattern command (which actually comes second)you specify
whether you want to fill your rectangular area with a solidblackrule,a finely
dottedgray-scale pattern,ora predefine linearpattern.AndwiththeSpecify
Pattern command you can indicate which
particular dotted or linear pattern
you want. You always send the Specify Pattern command before the Print
Pattern command, even if you want a solid black rule.
To indicate the particular pattern you want, send the following command.
The general meaning of then value you enter actually depends on the com-
mand you put after this:
<ESC>
*C n G
If you want a solid black rule it doesn’t matter what you put in for
n, as the
printer ignores it.
Ifyou want a 1-scaledottedpattern,fern you enter hereapercentagenumber
from 1to 100indicatingthedensitywith which youwant the box filled,from
light to solid. Your n percentage will correspond to one of the eight gray-
scale densities in the chart below.
1- 2%0
3-10 Yo
89