Filter
Top Products
L A F A G
A c c
AC .VC,}C[:]
The default is(),0and “anchors” the fillto theoriginofthe current coordinate
system.
F t c
FT t>p{ [. Il(tl%ll}l] [, p~1ra1n2:]]
The relation between lhese three parameters and the meanings are given in
the table below.
type
1
‘2
3
4
1()
II
21
fill
solid (default)
solid
hatched
cross-hatched
gray
user-defined
LaserJet III pattern
param 1
ignored
ignored
line spacing
line spucing
shading level
fill index
pattern type
param2
ignored
ignored
line angle
line angle
ignored
ignored
ignored
For types 3 and 4:
● The Iine spacing isgi}en incurrent unitsundismeasured along the x-axis.
A zero value gives a solid fill and a negtitivc value invalidates the
command. The default value is I% of
t clist~ncePI to P2. If [hecurrent
unitsareplotterunits.turningscalingonor moving P1and P2 hasnoeffect
on the spacing. If user units are used, the spacing varies as PI and P2 are
moved: turning scaling off fi,xesthe spacing in the plotter unit equivalent
to the current user unit.
. The line angle is measured counterclockwise from thepositive x-axis. In
cross-htitching.the two set of lines are at 900.
. The lines are drawn using the current pen and line type.
Fortype 10,theshadinglevelisexpressed as apercentageofbkrck;Oiswhite.
100 is black.
113