Filter
Top Products
For type 11,the fill index isas specified in command RF; if an RF command
has not been given, solid fill is used.
For type 21, the pattern type is a number between 1and 6, corresponding to
the patterns defined in the standard mode.
If any parameter or combination is outside the values in the table, the
command is ignored.
L a c
LA kind, ~’alue[, kind, value [. kind, value ;]]
This command specifies how lineends and linejoins are physically shaped.
Use this command when drawing lines thicker than 0.35 mm.
The relation between and meaning of the parameters are given in the
followin~ table:
ki!zd
1 line end
2
linejoin
3
miter limit
~’alue
1
butt (default)
~
square
3 triangular
4
round
1
mitered (default)
2
mitered/beveled
3
triangular
4
round
5
beveled
6
none
1to 32,767 (default: 5)
For a line end other than a butt end, add 1/2line width to the length.
If the miter in a mitered linejoin exceeds the miter limit, itistruncated. If the
miter in a mitered/beveled linejoin exceeds the miter 1imit,a beveledjoin is
used.
The miter limit is the ratio (miter length)/(line width). Miter limits smaller
than 1are rounded up to 1.
For thin lines (line width <=0.35 mm). the lineend isalways round, and line
joins is also round.
114