Star Micronics 4111 Printer User Manual


 
Factory settings are programmed into the Star LaserPrinter 4111when it is
built at the factory. Your printer keeps the factory settings for itsparameters
in ROM; they never change. You can copy them into the current settings or
any other settings as needed. But the only way you can return to the factory
defaults is from the control panel; no commands do this.
A few factory default settings are as follows:
Item
Fuetory deftiult settincq
Emulation HP LaserJet III
Feeder
Multi-purpose tray
Number of Copies 1
Orientation
Portrait
Font 10-pitch 12-pointCourier (internal)
Lines/inch
6 lines per inch
The user default setti}?gsare the normal default settings. The printer keeps
them even when you turn off the power. There are two settings: Mode 1and
Mode 2. The Mode 1isthe normal default seton power-up or hard reset. You
can select either Mode 1or Mode 2 by using [PROGRAM] button in normal
offline mode.
When you turn on the printer, these user default settings get copied into the
initial and current parameter settings.
You probably will not often change the Star LaserPrinter 4111’sinitial set-
tings (sometimes called “session settings”). You’11likely only change them
when you want to use a different printer emulation than normal. These initial
settings stay the same as the user default settings until you change them.
On the other hand, your software will probably change the (urrent settings
many times within the same document, with every change of font or print
style.
15