Filter
Top Products
2. Slide the drive out from the front of its bay in the removable media assembly.
Push the drive from the back to start the removal process.
3. Place the drive on an antistatic mat.
4.5.3 What Next
To install the CD-ROM or tape drive, complete this task:
Section 4.6 “How to Install a CD-ROM or Tape Drive” on page 139
4.6 How to Install a CD-ROM or Tape Drive
4.6.1 Before You Begin
Know the configuration guidelines for installing removable media devices. For
detailed information, see your Sun Enterprise 220R Server Owner’s Guide.
Complete these tasks:
Section 2.1 “How to Power Off the System” on page 54
Section 2.4 “How to Position the System for Service” on page 60
Section 2.6 “How to Remove the System Cover” on page 65
Section 2.8 “How to Avoid Electrostatic Discharge” on page 69
Section 4.3 “How to Remove the Removable Media Assembly (RMA)” on page 132
4.6.2 What to Do
1. If necessary, remove the plastic filler panel from the removable media assembly
plastic cover.
On the back side of the RMA cover, push the filler panel retainer tabs inward to
disengage the filler panel.
2. If you are replacing a defective drive, make sure that the jumper settings on
the new drive match the settings on the old drive.
3. Slide the CD-ROM or tape drive into its drive bay.
Align the two screw holes on each side of the drive with the corresponding holes
in each side of the drive bay.
Removing and Installing Storage Devices 139