7. Reattach, close, and lock the rack doors as appropriate.
2.14.3 What Next
For information about placing the system into the rack glides, see:
Section 2.15 “How to Place the System Into the Rack Glides” on page 81
2.15 How to Place the System Into the Rack
Glides
This procedure assumes that the slide assembly is already installed in the rack. For
further information on assembling the slide assemblies and rack enclosures, see the
Sun Enterprise 220R Server Setup and Rackmounting Guide.
Caution - The chassis is heavy. Two people are required to place the system into the
rack enclosure glides in the following procedure.
2.15.1 Before You Begin
Complete the following tasks:
Identify a helper to assist you in removing the system.
Verify that your helper can safely lift and carry 34 lbs (17 kg), which is
approximately half the weight of a fully-equipped system.
Assemble the correct tools for the procedure. See Section 2.13 “Tools Required for
Installation and Service” on page 77.
Open (and remove) the rack enclosure front door.
Preparing to Service the System 81