Filter
Top Products
2.2 How to Power On the System
2.2.1 Before You Begin
If a terminal or local console is not already connected to the system, you need to
install one before continuing the startup procedure. For information, see:
Section 2.10 “About Communicating With the Server” on page 73
Section 2.12 “How to Configure a Local Graphics Console” on page 75
Note - Use the Reconfiguration Boot procedure instead of the power-on procedure if
you have just installed an internal or external device or any new part that plugs into
the main logic board except a CPU or a DIMM. See Section 2.3 “How to Initiate a
Reconfiguration Boot” on page 58 for further information.
Preparing to Service the System 55