Filter
Top Products
7.12.2.4 OBP setenv Command
To set the value of an OpenBoot PROM configuration variable stored in NVRAM,
enter the OBP setenv command at the OBP ok prompt, as shown in the following
example.
Caution - If the NVRAM is a new part, you must reset the three OpenBoot PROM
configuration variables shown in this example. These variables are named
banner-name, enclosure-type, and energystar-enabled? and they must be
set to the values shown in the example.
ok setenv banner-name = Sun Enterprise 220R
ok setenv enclosure-type = 540-4284
ok setenv energystar-enabled? = false
ok printenv
variable name Value Default Value
scsi-initiator-id 7 7
keyboard-click? false false
keymap
ttyb-rts-dtr-off false false
ttyb-ignore-cd true true
ttya-rts-dtr-off false false
ttya-ignore-cd true true
ttyb-mode 9600,8,n,1,- 9600,8,n,1,-
ttya-mode 9600,8,n,1,- 9600,8,n,1,-
pcia-probe-list 1 1
pcib-probe-list 1,3,2,4,5 1,3,2,4,5
enclosure-type 540-4284
banner-
name Sun Enterprise 220R
energystar-enabled? false
mfg-mode off off
diag-level min min
#power-cycles 35
system-board-serial# 5014450071228
system-board-date 371c1bc9
fcode-debug? false false
output-device screen screen
input-device keyboard keyboard
load-base 16384 16384
boot-command boot boot
auto-boot? true true
watchdog-reboot? false false
diag-file
diag-device net net
boot-file
boot-device disk net disk net
local-mac-address? false false
ansi-terminal? true true
screen-#columns 80 80
screen-#rows 34 34
silent-mode? false false
(continued)
222 Sun Enterprise 220R Server Service Manual ♦ January 2000, Revision A