Filter
Top Products
Control Code Command Changes
101
<data> Data to be entered into the data fields of the
Buffered Form.
^G Command Terminator
Example: To print the form defined as TEST 1 in Example 2, page 100,
send the following command:
^IFORM,ETEST 1^GABCDEF^-^G
This would print ABCDEF as 0.5 x 0.5 inch block characters:
Control Code Command Changes
Within the Buffered Form Execute <data> field, the ^-, ^+, ^*, and ^,
commands do not perform their usual functions, but instead behave as
described below:
^- Causes unfilled portions of the current data field to be padded
with spaces. This is used if there are insufficient data characters
to fill the current field. The entire data field is converted to spaces
if this is the only input in the field.
^+ Deletes any unused portions of a data field. No data will be
printed in the data field if this is the only input in the field.
^* This is identical in function to the ^- function, in that it causes the
rest of the current data field to be padded with spaces. The entire
data field is converted to spaces if this is the only input in the
field. All remaining fields in the buffer are also converted to
spaces unless the fields occur within a Copy Command (as
described in the
“Buffered Form Copy” on page 106).
^, This command performs a line feed unless it is used within a
Copy Command. Refer to
“Buffered Form Copy” on page 106.