Filter
Top Products
182
Chapter 9 PGL Commands
Change SFCC Command (Normal and Execute)
This command allows you to change the current/default Special Function
Control Character to one of your choosing. SFCC command characters may
be selected from ASCII characters in Hex address 00-FF. The SFCC
command is:
NOTE: In addition to being able to change the SFCC using this command we
have added the ability to change it through the printer control panel.
The SFCC Parameter is located in the Configurations Menu.
Example: To change the SFCC from the default character (~, tilde) to the @
character use either the following commands:
Table 21. Change SFCC Command
Field Function Option/Modifier Selections
SFCC;
Special Function Control Character
(SFCC)
Enter the current Special Function Control
Character followed by SFCC, then end the
entry with the parameter delimiter.
n Designates the new SFCC
Command Character.
Enter desired ASCII character in decimal
format. The valid range of values is from
0 - 255.
You may also use the optional method of
actually specifying the desired character, if
it is a printable character, by using the
format ‘n’ to designate the character. If you
use this method enter the desired printable
character between single quote
characters.