Filter
Top Products
7
Front and Rear Panels
7-2
Phaser 480X Color Printer
Phaser 480X rear panel switches
Rear panel switches
Switch Function Settings
1 Reset/run
Up
: The printer resets and does not accept data while
the switch is in this position.
Down
. The printer runs a self-test, then proceeds to run
normally. Leave the switch
down
for normal operation.
2, 3, and 4 Diagnostics
Up
. When only Switch 4 is moved from
down
to
up
, the
printer prints a configuration page.
Down
. Normal operation.
5 Start Job
Up
: The Sys/Start job on the hard disk does not run.
Down:
The Sys/Start job runs if the file exists on the
disk.
6 Cleaning mode
Up:
At power-up, the printer rotates the rollers for a few
seconds, then stops the rotation. See “Cleaning the
printer” on page 4-5.
Down:
Normal operation.
7 Baud Rate
Up
: Fixed. Sets the serial communication parameters
to 1200 baud, software flagging, and ignore parity.
Down
: Variable. Lets you change the serial
communication parameters. The factory setting is 9600
baud, software flagging, and ignore parity.
8 and 9 Color correction See table “Switches 8 and 9: Color Correction Mode” on
page 7-3.