Filter
Top Products
2
Getting Set Up
2-20
Phaser 480X Color Printer
What happens at power-up
All indicators on the printerÕs front panel light up for approximately
30 seconds, and the printer goes through a series of self-tests. The printer
takes 1 to 3 minutes (depending on the amount of memory installed) to
warm up and complete the self-tests.
■ Check the indicators on the front and back panels of the printer:
■
Front
All indicators light for about 30 seconds, then all but the
POWER
indicator go out for about 60 seconds; the
READY light blinks for a
few seconds. When both the
POWER and READY lights are on, the
self-tests are complete.
■
Back
The status indicator lights for about 3 seconds; then goes off and
on Ñ Þrst rapidly; then slowlyÑ then it blinks regularly, indicating
normal operation.
■ When the self-tests run successfully, the Phaser 480X prints a
startup page (if the startup page is enabled), which takes from
1 to 4 minutes to print. The
READY indicator blinks while the
startup page is printing.
Note
When you receive your printer from Tektronix, the startup page is
disabled. Because it contains useful information on printer
configuration and print count, you might wish to enable the
startup page. When enabled, the startup page prints whenever
the printer is powered up or reset. Refer to “Enabling/disabling
the startup page” on page A-1 for general information. You can
also generate a configuration page with detailed information
useful for troubleshooting. Refer to “Configuration page” on
page A-3 for more information. Refer to the Phaser 480X
Drivers and Utilities Printing Reference for detailed
information.