Filter
Top Products
Printing
3
User Manual
3-11
Loading paper and transparencies
You load the paper tray with paper and transparencies in the same way:
1.
Pull the paper tray out of the printer and remove the plastic cover.
2.
On the paper tray, set the correct size by adjusting the paper
guides on the sides and rear of the tray. (Refer to ÒSetting paper
and transparency sizeÓ on page 3-8 for details.)
3.
Load paper or transparencies into the paper tray, with the printing
side down (the paperÕs non-printing side is marked with
Tektronix;
the transparencyÕs non-printing side is marked with
This Side up):
a.
While pressing down on the tab of the metal plate, place the
paper or transparencies (printing side down) into the tray.
b.
Make sure that the paper or transparencies are inserted evenly
and the hooks are positioned over the left and right corners of
the media.
c.
Do not Þll past the red line on the left inside wall of the
paper guide.
4.
Replace the plastic cover on the paper tray.
5.
Insert the paper tray into the slot in the front of the printer and
push it in until it stops.
8849-55
3a
3b
3c