Filter
Top Products
Getting Set Up
2
User Manual
2-19
Turning on the printer
After you have connected all the interface cables, you are ready to connect
the power cord and turn on the printer.
Caution
Before applying power, verify that the line voltage of your
printer (indicated on the printer’s rear panel) matches the line
voltage in your area to avoid damage to the printer.
To protect your printer from a power surge, make sure that the
power switch on the side of the printer is in the off position
before plugging in the cord.
1.
Plug the power cord into the printer and into a properly grounded
electrical outlet.
2.
Turn on the printer.
8849-20
LocalTalk
®
Serial
(RS-232)
Status
Parallel
*
See User Manual
Reset
Run
Variable
1 2 3 4 567
8 9
Diagnostics
1200
Baud Rate
Skip
Run
Startjob
**
Color Correction
*
CAUTION
This printer is set
to 115 VAC
1
2