Filter
Top Products
Printing
3
User Manual
3-13
Manual feed
Follow these steps to feed a single sheet of media into the printer. The
manual feed option is selected through the Windows and Macintosh drivers.
Typically, you would use manual feed when one of these conditions exist:
■ Paper is loaded in the paper tray and you want to print a
transparency of the same size.
■ Transparencies are loaded in the tray and you want to print on
paper of the same size.
1.
Make sure that the media you want to manually feed is the same
size as the media in the paper tray. If it is not, reset the size on the
paper tray to accommodate the single sheet of paper or
transparency.
Note
If you do not set the paper tray to the correct size for manual feed,
the print might jam or you might get an improperly placed image
on your print.
2.
Issue the print command on your computer. In the drivers, select
Manual Feed under Paper Source. The
MEDIA indicator blinks
for 60 seconds.
3.
Place the single sheet, printing side down, on the paper tray cover
and slide it in until it stops. If the paper tray is empty, the printer
immediately picks the single sheet. If the paper tray is not empty,
the printer waits for the
MEDIA indicator to stop blinking, then
picks the single sheet.
Phaser
480
8849-56