Filter
Top Products
MIX 56 User Manual 5 Owner Maintenance
122188-10 A0 Telect, Inc.
5-3
6. Gently insert the LED into the socket. If you encounter resistance,
do not force the LED into position. Move it until it slides easily into
place.
When the LED snaps into place, the installation is complete.
7. To test the new LED, insert a plug into the “M” (monitor) jack.
The LED flashes for about 30 seconds, then lights steadily.
8. Replace the LED panel faceplate by inserting the pin into the enclo-
sure hole, swinging the faceplate into position, and inserting the
captive screw into its slot so that the faceplate is flush with the
chassis. Tighten the screw.
REPLACING DSX JACKS
To replace a DSX jack, you must remove the LED panel faceplate, which is
held in place by a pin on one side and a screw on the other side. You must
pull the faceplate out at an angle in order to remove it without breaking the
pin, as described below.
Step Action
1. Loosen the screw holding the LED panel faceplate in place.
2. Carefully pull the end with the screw out slightly at an angle.