Filter
Top Products
MIX 56 User Manual 2 Installation
122188-10 A0 Telect, Inc.
2-17
3. Insert a mounting post through a washer and into a mounting post
hole on either side of the pin blocks, as shown below.
4. Using a 3/16 nut driver or a wrench, tighten the mounting post until
it is securely attached to the chassis.
5. Repeat Steps 3 and 4 on the other side of the pin blocks.
6. Gently place the holes on the back of the RJ Connector Retrofit
over the wire-wrap pins and carefully push the unit into place, as
Hinge Screws
Retainer
Clip Screws
Retainer
Clip Screw
Access Hole
s
Door
Mounting Post
Washer
Mounting
Post Hole
Mounting Post
Washer
Mounting
Post Hole