Filter
Top Products
4 Software Operation MIX 56 User Manual
4-18 Telect, Inc. 122188-10 A0
2. To make the screen readable again, change the baud rate setting for
the terminal (or PC running terminal emulation software) connect-
ed to the system so that it matches the new baud rate.
To Set Modem Detect
Tab to Modem Detect, press the spacebar to toggle between “Disabled” and
“Enabled,” and press Enter.
You must set this field to Yes if you intend to connect a modem to the MIX
56. If you set it to No, MIX 56 will not acknowledge modem hardware you
connect later, even if you reset the system or press the ACO switch as de-
scribed in Chapters 2 and 3.
To Specify SNMP Community Names
Step Action
1. Tab to the Read field, type a name (up to 16 characters) which
SNMP users will use for read privileges, and then press Enter.
2. Tab to the Write field and type a name (up to 16 characters) to
which SNMP users will use for read privileges, and then press En-
ter.
3. Tab to the Trap field, type a Trap name (up to 16 characters), which
SNMP users will use to receive traps, and then press Enter.
To Set SNMP Event Traps
Tab to SNMP Event Traps, press the spacebar to toggle between “Enabled”
and “Disabled,” and then press Enter.
To Specify Ethernet Settings
Step Action
1. Tab to the IP Address field and type the address. The IP address is
divided into four sets of numbers from 0 to 255 each. Press Enter
after typing in the four sets of numbers separated by a “.” (period).
NOTE
To turn off the Ethernet port, set the IP address to all zeros ( 0. 0. 0. 0).
2. Tab to the Subnet Mask, Gateway, and Trap fields and type the ap-
propriate addresses as described in step 1.