Filter
Top Products
1
2
3
4
5
6
7
8
9
10
11
12
9-14
WHEN THE GRAPHIC SYMBOLS FLASH ON THE TOUCH PANEL
5. CLEAR PAPER SYMBOL (Cont.)
7
Turn the knob in the direction of the arrow (clock-
wise) and pull out the transfer belt unit.
If the CLEAR PAPER symbol flashes as shown on the
right, be sure to carry out step 6. If this action is not sufficient,
the paper may be torn or be left in the copier.
8
Remove any misfed paper on the transfer belt.
9
If the misfed paper is gripped between the rollers,
remove it by rotating the lever in the direction shown.
Caution
- DO NOT touch the fuser unit and the metal area around it.
Since they are very hot, you could be burned or the shock
could cause an injury to your hand in the equipment.
- DO NOT touch the transfer belt. Touching it may cause
image failure.
10
If the misfed paper cannot be removed in step 9,
raise the exit guide of the fuser unit and remove it.
Exit guide
Transfer belt
Fuser unit