Filter
Top Products
5-34 Modifying Your Vanguard 7300
Removing and Replacing the Token Ring Card
Removing and Replacing the Token Ring Card
Installing the Token
Ring Card
When installing a Token Ring card, the first Token Ring card should be placed in
card slot 2, the first slot beside the CPU Card. Install subsequent Token Ring cards in
subsequent slots.
Use the steps in this table to install a Token Ring Card in a Vanguard 7300 enclosure:
Removing the
Token Ring Card
Use the steps in this table to remove the Token Ring Card from the Vanguard 7300
enclosure:
Step Action
1 Open the ejector levers.
2 Align the Token Ring Card with the card rails in the Vanguard 7300 chassis
slot.
3 Carefully insert the Token Ring Card in the card rails and slide the card
until you feel resistance.
4 Simultaneously press the ejector levers inward until they lock.
5 Tighten the captive screws.
6 Reconnect any connector cables.
Step Action
1 Disconnect any cables attached to the cards connectors.
2 Loosen the screws.
3 Open the ejector levers on the Token Ring card.
4 Pull the Token Ring card from the enclosure.
5 Place the Token Ring card on a clean, grounded, and static-free surface.
Caution
Avoid touching areas of integrated circuitry; static discharge can
damage these circuits.