Filter
Top Products
6-14 Replacing Power Supplies and Cooling Fans
Replacing Power Supplies and Cooling Fans, 7310 and 7330 Version 2
Removing and Installing the Intake Fan Module
Introduction The Vanguard 7310 and 7330 Version 2 Intake Fan Module contains a single fan.
The module is hot-swappable; it can be removed without turning off the system
power and without disrupting system service.
This section describes how to remove or install the Intake Fan Module.
Procedure Refer to Figure 6-4 and these steps to remove the Intake Fan Module:
Note
The Intake Fan Module is hot-swappable and can be removed without
disconnecting the power source and without disrupting system service.
1) Loosen the two screws
2) Carefully withdraw the module out the front of the chassis and away from the
midplane.
Figure 6-9. Removing the Vanguard 7310 and 7330 Version 2
Intake Fan Module
Installing an Intake
Fan Module
To install the Intake Fan Module:
Step Action
1 Insert the Intake Fan into the slot and insure that it is seated firmly.
2 Tighten the (2) mounting screws.