Filter
Top Products
3-16 Vanguard 7300 Installation
Installing the Vanguard 7300 in a Rack
Procedure for
Rack-mounting
Figure 3-10 shows the mounting hardware locations on the flanges of the Vanguard
7310 Version 1. For the locations on the Vanguard 7330 Version 1, refer to
Figure 3-11, For the locations on the Vanguard 7310 and 7330 Version 1, refer to
Figure 3-12. Use standard rack-mounting hardware (not supplied) to secure the
chassis in the rack.
Version 1 Rack-
mounting
Use these steps for rack-mounting a 7310 and 7330 Version 1 Series router:
1) Remove the front covers. (See the “Removing And Replacing Vanguard 7300
Front Covers” section on page 3-8.)
2) Two people are required to position the chassis and slide it into the front of the
rack.
3) Attach the front of the chassis to the rack:
• Secure the Vanguard 7310 Version 1 with mounting hardware at four locations,
two on each side of the front panel (Figure 3-10)
• Secure the Vanguard 7330 Version 1 at eight locations, four on each side of the
front panel (Figure 3-11)
Figure 3-10. Rack Mount Hardware Locations - Vanguard 7310
PORT 1
PORT 2
ACT100bT LINK
PORT 1
PORT 2
ACT100bTLINK
EXTPWR
ABT
RST
BFL
CPCI
USB 1COM 110/100 BASE T USB 0
CPU
PCI
PCI MEZZANINE CARD
PORT 1
PORT 2
ACT100bT LINK
P
M
C
2
D
E
B
U
G
HOT SWAP
RESET
P
M
C
1
11
7
3
8
W
A
N
4
0
Universal
Serial I/O
EXT PWR