Filter
Top Products
C-2
FCC Part 68 and Telephone Company Procedures and Requirements
FCC Part 68 and Telephone Company Procedures and
Requirements
Introduction This section describes the FCC Part 68 Telephone Company Procedures and
Requirements for DSU, T1, T3, and ISDN Interfaces.
Before You Begin Before a Vanguard 7300 Series router can be connected to the network, you must do
the following:
• Provide the local telephone company with the equipment’s registration
number.
• Order the proper connections.
How to Order
Connections
To order the proper connections, provide the telephone company with the following
information:
• Interface type.
• Required USOC jack connector number.
• Service code.
• Facility interface codes.
Troubleshooting
Your Connection
If any of your equipment is not operating correctly, immediately remove it from the
telephone line before damaging the network. If the telephone company is aware of
the problem, they might temporarily disconnect your service. Whenever possible, the
telephone company notifies you in advance of the disconnection.
If advance notice is not feasible, you are notified as soon as possible. Once you are
notified, you can correct the problem. If necessary, it is your right to file a complaint
with the FCC.
Interface Type USOC Jack
Connector
Service Code Facility Interface
Code
ATM and Voice Server
PMC versions of the T1/
PRI Digital Interface
RJ48C 6.0N 04DU9-BN
04DU9-DN
04DU9-1KN
04DU9-1SN