Filter
Top Products
Replacing Power Supplies and Cooling Fans 6-13
Replacing Power Supplies and Cooling Fans, 7310 and 7330 Version 2
Removing and Installing the Exhaust Fan Module
Introduction The Vanguard 7310 and 7330 Version 2 contains a rear exhaust module. The module
is hot-swappable; it can be removed without turning off the system power and
without disrupting system service.
This section describes how to remove or install the Exhaust Fan Module.
Procedure Refer to Figure 6-8 and these steps to remove the Exhaust Fan Module:
Note
The Exhaust Fan Module is hot-swappable and can be removed without
disconnecting the power source and without disrupting system service.
1) Loosen the four screws
2) Carefully withdraw the module from the rear of the chassis and away from the
midplane.
Figure 6-8. Removing the Vanguard 7310 and 7330 Version 2
Exhaust Fan Module
Installing an
Exhaust Fan
Module
To install the Exhaust Fan Module:
Step Action
1 Insert the Exhaust Fan into the slot and insure that it is seated firmly.
2 Tighten the (4) mounting screws.