Filter
Top Products
PSF/400 AFP Printing Using TCP/IP
Xerox 4500 PS ETH, Inst. & Operator's Guide
113
10. PSF/400 AFP Printing Using TCP/IP
This chapter provides configuration guidelines for AS/400 using TCP/IP.
The versions differ somewhat in the setup.
If you are running AS/400 version 3.1 or 3.6 , you should see section
13.1. If you are running AS/400 version 3.2 or 3.7 , see section 13.2.
Requirements:
Before IPDS printing using TCP/IP can be accomplished, the following
points need to be checked:
1. TCP/IP is installed and enabled
2. The relevant PTFs are applied
(for AS/400 3.1 and 3.6 only)
3. The WRKAFP2 command is compiled
(for AS/400 3.1 and 3.6 only)
Details on how to verify these items are supplied in a separate document
included on the documentation diskette.
See the file: AS400PTF.
PSF/400 is also a pre-requisite for IPDS printing. IPDS printing is
however possible for a period of time as a license can be obtained.
Once the above conditions have been met, the parameters have been
configured. The basic TCP/IP installation of the Xerox 4500 PS ETH IPC
(IPDS) must also have been completed before direct AFP / IPDS from
PSF/400 will be possible.
NOTE:
• The Maximum Transmission Unit (MTU) of the IP packet size that can
be used is 2000.
10.1 AS/400 version 3.1 and 3.6
This section describes the following configuration:
CRTDEVPRT samples
WRKAFP2 samples
10.1.1 CRTDEVPRT
Create a printer device description for version 3.1 or 3.6.
The value must be unique within the network.