Filter
Top Products
PSF/AIX Printing Using TCP/IP
Xerox 4500 PS ETH, Inst. & Operator's Guide
143
18. PSF/AIX Printing Using TCP/IP
This chapter provides details on:
Adding a TCP/IP attached printer
Setup of the KEEPALIVE TCP/IP feature
Requirements
Before IPDS printing using TCP/IP can be accomplished, the following
points need to be checked:
1. AIX1.2 with PTF U436937 or later must be installed.
The above conditions must have been met and the basic TCP/IP
installation of the PrintServer (IPDS) completed before direct AFP / IPDS
from PSF/AIX will be possible.
18.1 Adding TCP/IP attached printer
The port number is defined in the PSF/AIX SMIT “ Add a TCP/IP-Attached
Printer” panel.
1. Enter Printer name
PSF/AIX uses the printer name you specify. Enter a name of up to 8
characters.
2. Enter Internet address
The address in the TCP/IP network where the PrintServer is installed.
Enter a 32-bit dotted decimal notation (e.g. 192.0.2.1).
3. Enter Port number (5001)
The value chosen must match the value defined for the session in the
PrintServer (IPDS). 5001 is the default port number of the first IPDS
port no. in the PrintServer (IPDS).