Filter
Top Products
SNA IPDS and SCS Printing from MVS or VM
Xerox 4500 PS ETH, Inst. & Operator's Guide
133
c) Press <Enter> on <Configure default LU attributes>
d) Select:
Dedicated
Printer
<VTAM LU Name Prefix> (the name defined in VTAM)
<Hex> or <Decimal> (system dependant)
<ESC>
e) Enter <Starting dependent LU address>
(Make sure that the number is not already i n use by the existing profile)
f) Enter <Number of dependent LUs>
(This number should reflect the number of Xerox 4500 PS ETHs that
will connect to this SAA gateway. Each Xerox 4500 PS ETH uses
one LU)
g) Enter the rest of the parameters. They should be copied from the
existing PU profile.
h) NOTE
The value for ‘802.2 Local Service Access Point’ must be defined in the
Xerox 4500 PS ETH as ‘Remote SAP’.
The value for ‘node id’ must be defined in the Xerox 4500 PS ETH
as ‘Block number’ (first three digits) and ‘ID number’ (last five digits).
i) Press <ESC> and choose <YES> to create a new PU profile
5. Choose Configure Downstream PUs
This is where you actually define each of the Xerox 4500 PS ETHs to the SAA
gateway.
Each Xerox 4500 PS ETH is considered a PU.
a) Press <insert>
b) Enter <downstream PU name> (e.g. ida01)
c) Enter <downstream LU address> (always 02)
d) Enter <Number of downstream LUs> (always 1)
e) Enter <Logical Adapter Name> (the name of the SAA logical adapter
that should be used to communicate with the Xerox 4500 PS ETH In
the above figure it would be the Token Ring adapter. If you have
created a new Data Link Adapter in step 3), this is the one.
f) Enter <MAC address> and <802.2 remote node address> (The MAC
address of the Xerox 4500 PS ETH)
g) Leave the rest of the parameters at default value, press <ESC> and
choose <YES> to create a downstream PU.
h) NOTE:
The <802.2 remote service access point> is the ‘Local SAP’ in the Xerox 4500
PS ETH.
6. Choose Configure LUs for Downstream PUs
a) Press <enter> on the highlighted line showing: 002 (0x02)
b) Choose <Host PU profile>