Filter
Top Products
PSF/400 AFP Printing Using TCP/IP
Xerox 4500 PS ETH, Inst. & Operator's Guide
115
10.1.2 Configuring WRKAFP2 for direct TCP/IP connection
WRKAFP2 DEVD (PRTPS123 )
RETRY (2)
TCPIP (*YES)
RMTSYS (‘192.0.110.21’)
PORT (5001)
ACTTMR (170)
INACTTMR (*NOMAX)
DEVD This value must match the DEVD in the printer device
description.
RETRY Specifies the number of retry attempts to establish a session
TCPIP This value must be set to *YES.
RMTSYS An IP address or a host name may be used for this parameter. In
this example, an IP address is used. When configuring the IP
address parameter for the Xerox 4500 PS ETH IPC (IPDS), an
IP address (and not a host name) must be used.
PORT This value must match the value used for the Xerox 4500 PS
ETH (IPDS) TCP port parameter. The Port no. 5001 is the
default port number of the first IPDS port on the Xerox 4500 PS
ETH (IPDS).
ACTTMR This value specifies the number of seconds PSF/400 will wait
for the Xerox 4500 PS ETH to respond to an activation
request. If the printer does not respond within this period,
PSF/400 will terminate.
INACTTMR This value specifies the length of time PSF/400 will maintain a
session with the printer while there are no spooled files with a
status of RDY.
NOTE: The values in the WRKAFP2 command vary slightly according
to the PTF level and the operating system version.
Consult the following document supplied on the diskette for
details:
AS400PTF
10.1.3 Setting the CHGTCPA
If your environment has a need to make certain that a TCP/IP attached device
has not been powered off, you may use the TCP KEEP ALIVE parameter in
CHGTCPA. This value used for this parameter determines how long PSF/400
will wait for a response from a device before terminating.