Filter
Top Products
Configuration
Xerox 4500 PS ETH, Inst. & Operator's Guide
79
3.7.1 BOOTP process
So far, this chapter has only been dealing with the setting up of the
PrintServer from a BOOTP server. However, the PrintServer can also be
equipped with a so-called “ default configuration”. This default
configuration will be carried out if the PrintServer cannot detect a BOOTP
server at the time the PrintServer is powered on. The default settings are
similar to the ones defined on the BOOTP server. For an illustration of this
boot event, please see the flow chart below.
Power ON
Attach to
LAN
Send BOOTP
request
Transmit BOOTP
request
Answer
from BOOTP
server??
Default
config.
present??
Load
default
IP address
Ready to
print
Read BOOTPTAB
file:
- IP address
- bootfile (if any)
- microcode file
NO
NO
NO
YES YES
YES
Default Configuration