Filter
Top Products
AS/400 SCS Printing Using SNA
Xerox 4500 PS ETH, Inst. & Operator's Guide
118
11. AS/400 SCS Printing Using SNA
This chapter provides:
AS/400 definitions for 3270 SCS printing
Once these parameters have been configured, and the basic SNA
installation of the Xerox 4500 PS ETH (equipped with an FSL top module)
has been completed, direct SCS print will be possible. This method enables
printing of datasets that would have been printed on a 5256 twinax or 3287
coax attached printer.
If 3812-1 emulation is required then the TCP/IP connection described in the
“AS/400 SCS/DCA Printing using TCP/IP” section, should be considered.
If AS/400 Host Print Transform is being used then the TCP/IP connection
described in the “AS/400 Printing using TCP/IP LPR/LPD” section, should be
considered.
If IPDS printing is required, the TCP/IP connection described in the chapter
“PSF/400 AFP Printing Using TCP/IP” should be considered.
Requirements:
- Xerox 4500 PS ETH (equipped with an FSL top module) with 3270
emulation