Filter
Top Products
PSS/MVS AFP Printing Using TCP/IP
Xerox 4500 PS ETH, Inst. & Operator's Guide
136
15. PSS/MVS AFP Printing Using TCP/IP
This chapter provides:
JES installation statements
PSS Startup Procedure
PSS Printer Profile
Once these parameters have been configured and the basic TCP/IP
installation of the PrintServer (non-IPDS) has been completed, direct
AFP/ICDS from PSS / MVS will be possible.
Requirements:
- use of ida PSS, version 6.01 or higher
- use of TCP/IP for MVS, version 2, release 1
MTU size
Gateway statement for TCP/IP profile
• The Maximum Transmission Unit (MTU) of the IP packet for the
MVS system is recommended to be set up to 2000.
NOTE: The MTU size should not exceed the maximum size sent through
the control unit. Failure may lead to transmission problems.
15.1 Sample PSS/MVS JES2 initialisation statements
FSSDEF(PSS4) PROC=PSS4,HASPFSSM=HASPFSSM
/* From the system PARMLIB
PRT410,CLASS=A,DRAIN,MODE=FSS,ROUTECDE=PSS410,FSS=PSS4
PRMODE=(LINE,PAGE),UCS=0,WS=(W,R,Q/F)
PRT411,CLASS=A,DRAIN,MODE=FSS,ROUTECDE=PSS411,FSS=PSS4
PRMODE=(LINE,PAGE),UCS=0,WS=(W,R,Q/F)
Example of PSS/MVS JES2 printer definition