Filter
Top Products
Installation
Xerox 4500 PS ETH, Inst. & Operator's Guide
24
2.6 Installing upgrade modules
This section provides installation guidelines for IPDS or FSL upgrade modules.
1. Disconnect all cables to the Xerox 4500 PS ETH.
2. Loosen the thumbscrews and pull out the interface
3. Place the upgrade module (be it IPDS or FSL) on the 4 plastic spacers
on the base module. Make sure that the pins on the connector J(x) fit
correctly.
4. Remount the interface into the printer and fasten th e 2 thumbscrews
loosened in step 2.
5. Generate a settings printout to verify the installation of the upgrade
module.
The printer and network installation is now complete. For advanced
configuration, see the chapter “Configuration”.
FIRMWARE DOWNLOAD
Firmware download when the PrintServer is equipped with a top
module can be done easily via PSinst32.
See the next section on Psinst32 for details.