Filter
Top Products
XEROX WIDE FORMAT COPY SYSTEM Getting to know the WIDE FORMAT COPY SYSTEM • 25
The Printer and the Controller
For detailed operating instructions about the Printer and Controller
components of the WIDE FORMAT COPY SYSTEM and about network
connectivity, refer to the documentation listed below.
• The XEROX WIDE FORMAT 8825/8830 Printer Operator
Manual
• XEROX WIDE FORMAT 8850 and 510dp Series Printer
Operator Manual
• XEROX WIDE FORMAT 721P Engineering Printer Operator
Manual
• ColorgrafX X2 User Guide
The Controller Setup Guide/Network Administrato Guide (NAG) contains
the details for setting up the Controllers used with XEROX WIDE
FORMAT 8825/8830/8850/510dp Series and 721P printers. The Network
Administrator's Guide contains valuable information about network
connectivity and help in determining network connectivity settings.
The Web Printer Manager Tool User Guide contains the details for
configuring the settings for the Controller used with the XEROX WIDE
FORMAT X2 TECH color printer.
Powering On the WIDE FORMAT
COPY SYSTEM
To power on the XEROX WIDE FORMAT COPY SYSTEMS, you first
must switch on the Scan System and wait for 30 seconds or check that a
P is displayed on the status LED in the back of the Scan System. Then
switch on the Printer, then the Controller.
Follow the instructions provided in this section for your system.
When the WIDE FORMAT SCAN SYSTEM is present, the DDS
parameter must be set to Enabled in order to enable the COPY/SCAN
functionality. If the DDS parameter is set to Disabled, COPY/SCAN
functionality will not be enabled.
The default for this parameter is disabled. You must ensure that it is set
to Enabled when powering on the XEROX WIDE FORMAT SCAN
SYSTEM for the first time. After setting the DDS parameter, wait 30
seconds, and then power the system off then on. Once you enable this
parameter, it will remain enabled (even following future software
upgrades).
For the XEROX WIDE FORMAT COPY SYSTEM 510 Series or 8825,
8830, and 8850, you can set this parameter from either the
CONTROLLER CONFIGURATION screen of the Printer Control Panel or
the PRINTER SETUP/Miscellaneous page of the Web PMT. For the
XEROX WIDE FORMAT COPY SYSTEM 721P, you can only set this
parameter from the Web PMT. Refer to the 8825/8830/8850/510
Series/721P Controller Setup Manual or the Web PMT Printer Manager
Tool User Guide for more information.
Initial power-on