Filter
Top Products
26 •Getting to know the WIDE FORMAT COPY SYSTEM XEROX WIDE FORMAT COPY SYSTEM
To switch on the Scanner, press the Power On/Off Switch on the back of
the Scanner to the On (I) position as shown below. Wait for 30 seconds
or until a P is displayed on the status LED.
When the Scanner is switched on, the fluorescent lamp inside the
Scanner illuminates immediately. If the lamp does not illuminate, refer to
the "Problem solving" section of this guide.
Certain Controllers receive their power from the Printer. They do not
have a separate power switch.
NOTE: Ensure that the Scanner is switched on first and the P is
displayed in the Status Indicator window.
To power on these Controllers and the Printer, do the following:
1. Switch the Printer Power Switch to the Off (O) position.
2. Switch the Circuit Breaker Switch to the On (I) position.
3. Switch the Printer Power Switch to the On (I) position.
Switching on the
Scan System
Switching on the
Controller and the Printer
(XEROX WIDE FORMAT
COPY SYSTEM
8825/8830/8850)