Zebra Technologies 105SL Plus Printer User Manual


 
Introduction
Control Panel Display
22
P1056468-002 7/3/13
Set the Media Type
Select the type of media that you are using.
See Media Type on page 85 for more information.
Select the Media Sensor
Select the media sensor that is appropriate for the media that you
are using.
See Sensor Type on page 102 for more information.
Select the Print Method
Specify if ribbon is being used. Thermal Transfer media requires
ribbon for printing while Direct Thermal media does not.
To determine if you need to use ribbon, see When to Use Ribbon
on page 49.
See Print Method on page 85 for more information.
Adjust the Print Width
Specify the width of the labels being used.
See Print Width on page 85 for more information.
Set the Maximum Label Length
Set the maximum label length to a value that is at least 1.0 in.
(25.4 mm) greater than the actual label length plus the interlabel
gap. If you set the value to one that is smaller than the label length,
the printer assumes that continuous media is loaded, and the printer
cannot calibrate.
See Maximum Label Length on page 86 for more information.