Printer Setup and Operation
Load the Media
62
P1056468-002 7/3/13
5. Thread the media under the media dancer assembly roller (1), the media guide roller (2),
and then the upper media sensor (
3).
c. Place the roll of media on the media supply
hanger. Push the roll back as far as it will go.
c. Drape the media over the media supply
hanger.
d. Slide in the media supply guide until it
touches the edge of the roll.
d. Slide in the media supply guide until it
touches the edge of the media.
Roll Media (Continued)
Fanfold Media (Continued)
Important • Make sure that you thread the media under these components. If you thread
the media over them, the media obstructs the ribbon sensor and causes a false
RIBBON OUT error.
2
3
1