Zebra Technologies 105SL Plus Printer User Manual


 
Printer Configuration and Adjustment
Changing Printer Settings
84
P1056468-002 7/3/13
Tear-Off
Position
If necessary, adjust the position of the media over the tear-off bar after printing.
Higher numbers move the media out (the tear line moves closer to the leading edge of
the next label).
Lower numbers move the media in (the tear line moves closer to the edge of the label
just printed).
Accepted values:
–120 to 120
Related ZPL command(s):
~TA
SGD command used:
none
Control panel menu item: TEAR OFF on page 21
Printer web page:
View and Modify Printer Settings > General Setup >
Tear Off
Print Mode Select a print mode that is compatible with your printer options.
Accepted values:
TEAR OFF—The printer prints label formats as it
receives them. The printer operator can tear off the
printed labels any time after they print.
PEEL—The printer peels the label from the liner
during printing and then pauses until the label is
removed. The liner winds onto the rewind spindle.
REWIND—The printer prints without pausing
between labels. The media is wound onto the rewind
spindle after printing.
CUTTER—The printer prints a label and then cuts it
free.
Related ZPL command(s):
^MM
SGD command used:
media.printmode
Control panel menu item: PRINT MODE on page 21
Printer web page:
View and Modify Printer Settings > General Setup >
Print Mode
Table 7 • Print Settings (Continued)
1
2
1
Media direction
2
Factory-set tear line location at position 000