3Com 2200 Switch User Manual


 
Setting the Multicast Limit 11-7
Figure 11-2 shows the order in which the discard decisions are made.
Figure 11-2 How Frame Processing Affects Transmit Bridge Port Statistics
Setting the
Multicast Limit
You can assign a multicast packet firewall threshold to a bridge port on the
Switch 2200 to limit the forwarding rate of multicast traffic originating on
the Ethernet segment connected to the port. For more information about
the multicast packet firewall, see Chapter 7: Bridging Extensions in the
SuperStack™ II Switch 2200 Operation Guide.
Default value The default is zero (0), which means that no threshold is set.
To set the multicast limit:
1 From the top level of the Administration Console, enter:
bridge port multicastLimit
You are prompted for port type.
2 Enter
Ethernet, FDDI, or all.
You are prompted for port number(s).
3 Enter the number(s) of the port(s) or
all to set the threshold for all ports
on the bridge.
You are prompted for a new value for each port you specified.
txBlockedDiscs
txMtuExcDiscs
txMcastFilters
txAllFilters
txFrames
Frames forwarded to this bridge port
Frames discarded because transmit port blocked
Frames transmitted by this bridge port
processing of frames
Transmit Bridge Port Statistics
to Physical
Interface
=
Frames discarded because of user-defined
packet filter
Frames discarded because frame too large
Top-Level Menu
system
ethernet
fddi
bridge
ip
snmp
analyzer
script
logout
display
ipFragmentation
ipxSnapTranslation
addressThreshold
agingTime
stpState
stpPriority
stpMaxAge
stpHelloTime
stpForwardDelay
stpGroupAddress
port
packetFilter
summary
detail
multicastLimit
stpState
stpCost
stpPriority
address