2 INDEX
baud rate
console serial port 3-2
bell, warning 4-1
blocking state 11-5
bridge
See also packet filter
address threshold, setting 10-6
aging time, setting 10-6
designated 11-3
IP fragmentation, enabling 10-5
IPX Snap Translation, enabling 10-5
menus 2-5
Spanning Tree
bridge priority, setting 10-7
enabling 10-7
forward delay, setting 10-9
hello time, setting 10-9
maximum age, setting 10-8
statistics, displaying 10-1
bridge port
MAC addresses
adding 11-12
flushing 11-13
freezing 11-13
listing 11-11
removing 11-12
multicast limit, setting 11-7
Spanning Tree
enabling 11-8
path cost, setting 11-9
port priority, setting 11-10
states defined 11-5
statistics, displaying 11-1
bridging
commands, full 10-1 to 10-10
commands, quick 1-4
mode defined 10-4
broadcast address 3-4
bulletin board service B-1
C
code. See scripting and packet filter
commands
and entering values 2-9
quick 1-1
using 2-8
community strings
setting 3-16
values 3-15
CompuServe® B-2
connectPolicy
configuring 8-4
Console serial port
for management 3-1
reasons for disconnecting 2-11
rebooting the system 4-4
setting baud rate 3-2
Control keys
enabling 2-11
conventions
notice icons 3
cost
See also metric
of IP interface 3-4
Spanning Tree settings 10-4, 11-3, 11-9
CTL+C (abort) 2-11
CTL+X (reboot) 2-11
D
datagrams, statistics 3-14
date
formats 4-4
setting system 4-3
default route
defined 3-8
displayed 3-8
removing 3-10
setting 3-10
destination address
for SNMP trap reporting 3-18
destination address group mask (DAGM) 13-1
destination IP address
in routing table 3-7
destination port group mask (DPGM) 13-1
direct, route status 3-8
documentation
for the Switch 2200 system 4
E
editor
for packet filters 12-17
for scripts 2-13
EMACS editor 2-13, 12-17
eq opcode A-4
Ethernet
analyzing segments 9-1 to 9-6
commands, quick 1-5
fragmenting packets 10-5
menus 2-4
packet fields 12-6