3-18 CHAPTER 3: CONFIGURING MANAGEMENT ACCESS TO THE SYSTEM
3 Enter the trap number(s).
Separate a series of more than two trap numbers with a hyphen (-) and
nonsequential trap numbers by commas. Enter
all if you want to enable all
the traps for the destination.
The trap numbers you enter allow the trap specified by that number to be
sent to the destination address when the corresponding event occurs. No
unlisted traps are transmitted.
This example shows a trap configuration:
Enter the trap destination address: 158.101.222.3
Enter the trap numbers to enable (1-5,10,12-22|all)
[1-5,10,12-22]:
all
Address Error If the destination address you entered is not a valid end-station or if the
agent does not have a route to the destination, you receive this message:
Trap address invalid or unreachable
If you see this message, confirm the address of the end-station and confirm
that it is online.
Removing Trap Destinations
When you remove a destination, no SNMP traps will be reported to that
destination.
To remove a destination:
1 From the top level of the Administration Console, enter:
snmp trap remove
You are prompted for a trap destination address, that is, the IP address of
the SNMP manager that will no longer receive the traps.
2 Enter the SNMP trap reporting destination address you want to remove.
The destination address is removed and you return to the previous menu.
Top-Level Menu
system
ethernet
fddi
bridge
ip
➧snmp
analyzer
script
logout
display
community
➧trap
display
addModify
➧remove
flush
smtProxyTraps